E39 series BMW 5

since 1996-2001 of release

Repair and car operation



E39 BMW
+ Introduction
+ Maintenance instruction
+ Current leaving and service
+ Engine
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Manual transmission
+ Automatic transmission
- Coupling and power shafts
   - Coupling
      Removal, installation and coupling check
      Air removal from a coupling hydraulic actuator
      Removal and installation of the mechanism of switching off of coupling
      Removal and installation of the working cylinder of coupling
   + Power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ electric equipment Schemes
+ System of onboard diagnostics


Heavy Metal & Reflected Иногда изначальный врожденный Цвет ауры по дате рождения определяют в России.


Removal and installation of the mechanism of switching off of coupling

Noise in the bearing of switching off of coupling in the switched-off condition, i.e. at the pressed pedal of coupling indicates existence of damage to the bearing.

 REMOVAL

1. Remove a check point, address to the Section Removal and RKPP and AT installation.

2. Remove the bearing of switching off of coupling (1) from primary shaft of RKPP. Take out the lever of switching off (4) of a bracket (5).

3. Check a hand the bearing of switching off of coupling. For this purpose slightly compress it and turn. It should rotate easily. Otherwise replace it.


 INSTALLATION

1. Clear the lever and slightly grease with Molykote Longtherm greasing of 2 surfaces of sliding (F).

2. If a bracket (5) and a sharovy finger (6) have damages, replace them.

At RKPP S6S 420G the bracket and a sharovy finger should be replaced surely. The RKPP type is specified in the bottom line of designation. Designation can be on the following places: below in the RKPP center, in the bottom of a casing and on the RKPP extension piece on the left side.

3. Wipe directing plug (7). Do not grease the plug with greasing. Otherwise the bearing can jam on the plug.

4. Put on the lever of switching off of coupling with the bearing primary shaft of RKPP and fix a bracket.

5. Clear surfaces of sliding (2) bearings. Do not wash out it gasoline. Surfaces of sliding (2) bearings should adjoin to surfaces of sliding (3) levers, see иллюстр. 4.2.

7. Establish RKPP, address to the Section Removal and RKPP and AT installation.