E39 series BMW 5

since 1996-2001 of release

Repair and car operation



E39 BMW
+ Introduction
+ Maintenance instruction
+ Current leaving and service
+ Engine
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Manual transmission
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
- Suspension bracket and steering
   - Forward suspension bracket
      Electronic control by rigidity of shock-absorbers (EDC)
      Removal and installation of an amortization rack
      Dismantling amortization rack/shock-absorber. Removal and installation of a screw spring
      Check and shock-absorber utilization
      Removal and installation of the bearing of a wheel
      Removal and installation of a beam of a forward suspension bracket
      Removal and installation of the lever of a cross-section suspension bracket
   + Back suspension bracket
   + Steering
+ Body
+ Onboard electric equipment
+ electric equipment Schemes
+ System of onboard diagnostics


Heavy Metal & Reflected


Removal and installation of the bearing of a wheel

If at turns, especially abrupt, from the region of an arrangement of a wheel external in relation to turn noise is heard, it indicates damage of the bearing of a wheel.


 REMOVAL

1. Remove a brake disk, address to the Section Removal and installation of a brake disk/support of a forward brake.

 

2. Disconnect the pulse ABS (1) sensor. Address to an accompanying illustration.
3. Remove a tip of steering draft from a rotary support, address to the Section Removal and installation of a tip of steering draft.
4. Unscrew the bottom bolt of fastening 3/4. Remove a rotary fist (5) down from an amortization rack. If necessary put marking of provision of a rack, address to the Section Removal and installation of an amortization rack.
5. Turn out 4 bolts (8) and remove the bearing (6) from a rotary fist.


 INSTALLATION

1. Clear adjacent surfaces of the bearing of a wheel and a rotary fist, and also carving openings. Remove greasing traces.
2. Establish the bearing and fix it new being self-stopped bolts the moment of 110 Nanometers.
3. Establish a rotary fist up, on a rack against the stop that the put labels coincided previously.
4. Insert tightening a bolt and tighten with a being self-stopped nut effort of 80 Nanometers.
5. Establish on a rotary support a head of steering draft, address to the Section Removal and installation of a tip of steering draft.
6. Fix the pulse ABS sensor.
7. Establish a brake disk, address to the Section Removal and installation of a brake disk/support of a forward brake.