E39 series BMW 5

since 1996-2001 of release

Repair and car operation



E39 BMW
+ Introduction
+ Maintenance instruction
+ Current leaving and service
+ Engine
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Manual transmission
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
- Suspension bracket and steering
   + Forward suspension bracket
   + Back suspension bracket
   - Steering
      Security measures at work with a safety cushion
      Removal and installation of a steering wheel
      Removal and installation of the top facing of a steering column
      Removal and installation of a tip of steering draft
      Removal and installation of steering draft
      Hydropump fastening
      Removal of air and filling of hydrosystem of the amplifier of a wheel with liquid
      Check and adjustment of corners of installation of wheels
+ Body
+ Onboard electric equipment
+ electric equipment Schemes
+ System of onboard diagnostics


Heavy Metal & Reflected



Security measures at work with a safety cushion

   •  Replacement and control of a safety cushion should be carried out only on HUNDRED. By no means it is impossible to carry out any constructive changes on a pillow.

   •  The steering wheel having a safety cushion, it is necessary to replace only with a wheel resolved by the manufacturer of the car.

   •  It is not necessary to paste over or fit a surface of a pillow of a steering wheel or to perform any other works with it. The pillow can be cleared only the towel dry or moistened with water or a cleaner resolved by the manufacturer of the car.

   •  The safety cushion does not replace seat belt application. The people being in the car, should be fastened by belts.

   •  The seat of the driver should be adjusted according to the sizes of a body.

   •  It is not necessary to have ahead of a children's seat. Children till 12 years should be transported only on back sitting.

   •  Between a safety cushion and the person it is impossible to place any subjects.

   •  The cover of a safety cushion cannot be used as the shelf.

   •  If as a result of failure the safety cushion worked, it is necessary to replace the control unit, knot of a safety cushion and the contact block with the new.

   •  Before works with a safety cushion or electric equipment it is necessary to disconnect a negative cable from the storage battery. Then it is necessary расстыковать shtekerny connection on a steering column.

   •  To store a safety cushion it is necessary so that its amortization layer looked up.

   •  The removed and not worked safety cushion should be stored in a room the free access in which is closed.

   •  It is impossible to process a safety cushion greasing, cleaners or similar structures.

   •  Knot of a safety cushion and control unit ударочувствительны. If the pillow was dropped from height more than 50 cm, it cannot be applied more. When falling from smaller height the pillow is necessary for checking on HUNDRED.

   •  By production of welding works it is necessary to attach the plug of a welding cable in close proximity to a welding place. The cable of weight of the storage battery is necessary for disconnecting, and the negative plug of the battery to isolate to exclude possibility of casual contact. Rasstykuyte also shtekerny connection of a pillow to a gas generator.

   •  The knot of a safety cushion and the control unit to subject even to short-term influence of temperature above +75°С is not allowed. The damaged elements of a pillow are not subject to repair. Unauthorized opening of elements of a pillow is not allowed. Before installation again check, whether the cable of weight of the storage battery is disconnected.

   •  By no means it is impossible to utilize a safety cushion independently. Danger of explosion!.

   •  Observe security measures at work with the device of a tension of a belt, address to the Security measure Section at the handling of the device of a tension of a belt.