E39 series BMW 5

since 1996-2001 of release

Repair and car operation

+ Introduction
+ Maintenance instruction
+ Current leaving and service
+ Engine
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Manual transmission
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
- Suspension bracket and steering
   + Forward suspension bracket
   + Back suspension bracket
   - Steering
      Security measures at work with a safety cushion
      Removal and installation of a steering wheel
      Removal and installation of the top facing of a steering column
      Removal and installation of a tip of steering draft
      Removal and installation of steering draft
      Hydropump fastening
      Removal of air and filling of hydrosystem of the amplifier of a wheel with liquid
      Check and adjustment of corners of installation of wheels
+ Body
+ Onboard electric equipment
+ electric equipment Schemes
+ System of onboard diagnostics

Removal and installation of the top facing of a steering column


1. Lower a steering column completely down and completely put forward.


2. Turn out a bolt (the shooter on an accompanying illustration).

3. Press the top facing from both parties in the area shown on an accompanying illustration, and remove upward.

4. Disconnect and remove the top part of facing.


1. If it is necessary, replace a nut of the top bolt of fastening.


2. Establish the top part and fix it. Thus the hook (1) should enter into a reception part (2).

3. Press down the top part sideways a steering wheel and fix it in the lower part.
4. Fix screws the top part.