E39 BMW + Introduction + Maintenance instruction + Current leaving and service + Engine + Systems of cooling, heating + Power supply system and release + engine Electric equipment + Manual transmission + Automatic transmission + Coupling and power shafts + Brake system - Suspension bracket and steering + Forward suspension bracket + Back suspension bracket - Steering Security measures at work with a safety cushion Removal and installation of a steering wheel Removal and installation of the top facing of a steering column Removal and installation of a tip of steering draft Removal and installation of steering draft Hydropump fastening Removal of air and filling of hydrosystem of the amplifier of a wheel with liquid Check and adjustment of corners of installation of wheels + Body + Onboard electric equipment + electric equipment Schemes + System of onboard diagnostics
|
Removal and installation of a tip of steering draft
|
1. Mark with paint the provision of a wheel concerning a nave. Thanks to it the otbalansirovanny wheel can be established in former situation. Weaken bolts of fastening of a wheel on the car standing on the earth. Lift and establish the car on supports and remove a wheel. 2. Unscrew a lock-nut of fastening of a tip of steering draft, address to the Section Removal and installation of a beam of a forward suspension bracket. |
3. Unscrew a nut of fastening of the spherical hinge at an inclined support. |
|
4. Disassemble the sharovy hinge by means of a standard stripper, for example, HAZET 779-1. |
|
5. Unscrew a tip of steering draft. Thus keep steering draft a wrench from a provorachivaniye.
|
At an otvorachivaniye count number of turns. It will facilitate adjustment later. Pay attention to existence of the right and left carving. |
|
|
|
1. Screw a tip on steering draft. The number of turns is equal earlier defined at a reversing. 2. Tighten a lock-nut of fastening of a tip the moment offered by Specifications. 3. Establish a tip in an inclined support. Fix it a new being self-stopped nut the moment offered by Specifications. 4. Establish and fix a forward wheel. Do not oil bolts or greasing. A wheel establish so that the markings put earlier at removal coincided. Lower the car on wheels. Tighten cross-wise bolts of fastening of a wheel the moment of 100 Nanometers. 5. Adjust a convergence, address to the Section Check and adjustment of corners of installation of wheels. |
|
|
|