E39 series BMW 5

since 1996-2001 of release

Repair and car operation



E39 BMW
+ Introduction
+ Maintenance instruction
+ Current leaving and service
+ Engine
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Manual transmission
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
- Suspension bracket and steering
   + Forward suspension bracket
   + Back suspension bracket
   - Steering
      Security measures at work with a safety cushion
      Removal and installation of a steering wheel
      Removal and installation of the top facing of a steering column
      Removal and installation of a tip of steering draft
      Removal and installation of steering draft
      Hydropump fastening
      Removal of air and filling of hydrosystem of the amplifier of a wheel with liquid
      Check and adjustment of corners of installation of wheels
+ Body
+ Onboard electric equipment
+ electric equipment Schemes
+ System of onboard diagnostics


Heavy Metal & Reflected



Removal and installation of steering draft

 REMOVAL

1. Mark with paint the provision of a wheel concerning a nave. Thanks to it the otbalansirovanny wheel can be established in former situation. Weaken bolts of fastening of a wheel on the car standing on the earth. Lift and establish the car on supports and remove a wheel.

2. Unscrew a nut of fastening of the spherical hinge at an inclined support.

3. Disassemble the sharovy hinge a stripper, for example, HAZET 779-1.

4. Remove a collar and shift a protective cover back.
5. Move a gear lath as far as possible.
6. Disconnect steering draft (shooter).


 INSTALLATION

1. Measure length of old steering draft. At new steering draft a tip screw so that to receive earlier existing size. To Zakontrita tip.
2. A lock-nut tighten the moment of 45 Nanometers.
3. If it is necessary, clear a finger of the spherical hinge and a place of its landing in a rotary support of greasing.
4. Check a protective cover and if necessary replace.
5. Fix steering draft on a gear lath the moment presented in Specifications.
6. Put on a protective cover and fix it a new collar. Watch that the cover was not overwound.
7. Insert a tip of steering draft into a rotary support. Screw a new being self-stopped nut and tighten it the moment specified in Specifications.
8. Establish and fix a forward wheel. Bolts of fastening of a wheel do not grease. A wheel establish so that the markings put at removal coincided. Lower the car on wheels. Tighten bolts of fastening of a wheel the moment of 100 Nanometers.
9. Adjust a track, address to the Section Check and adjustment of corners of installation of wheels.