The device, service, repair of BMW 5 of a series Е39 1996-2001 - Removal and installation of glass of a mirror//koolinarka.ru

E39 series BMW 5

since 1996-2001 of release

Repair and car operation

E39 BMW
+ Introduction
+ Maintenance instruction
+ Current leaving and service
+ Engine
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Manual transmission
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
- Body
   Care of a body
   Care of the panels of furnish made of vinyl
   Care of an upholstery and salon rugs
   Repair of insignificant damages of body panels
   Repair of considerable damages of a body
   Body gaps
   Removal and installation of a front bumper
   Removal and installation of shock-absorbers of a front bumper
   Removal and installation of a rear bumper
   Removal and installation of the shock-absorber of a rear bumper
   Removal and installation of a forward wing
   Removal and cowl installation
   Adjustment of provision of a cowl
   Removal and trunk lid installation
   Adjustment of provision of a trunk lid
   Removal and installation of back facing of a luggage carrier
   Removal and installation of the lock of a cover of the luggage carrier/cylinder of the lock
   Removal and installation of a gas-filled emphasis of a cowl/trunk lid
   Slip replacement / firm inscription
   Removal, installation and door adjustment
   Removal and installation of facing of a door
   Removal and installation of the door lock
   Removal and installation of the external handle of a door
   Removal and installation of the cylinder of the lock
   Removal and installation of the electric motor/microswitch of the uniform lock
   Removal, installation and adjustment of door glass
   Removal and installation of an electric window regulator
   Removal and installation of an external mirror
   Removal and installation of glass of a mirror
   Removal and installation of the case of an external mirror
   Removal and installation of an internal mirror
   Removal and installation of the central console
   Removal and installation of the electric motor of the movable panel of the hatch of a roof
   Removal and installation of a forward seat
   Device of a tension of a seat belt
   Security measures at the handling of the device of a tension of a belt
   Protection of the device of a tension of a belt
   Removal and installation of a back seat
   Removal and shelf installation under a headdress
   Removal and installation of a jalousie of back glass
+ Onboard electric equipment
+ electric equipment Schemes
+ System of onboard diagnostics

Heavy Metal & Reflected

Removal and installation of glass of a mirror

Before removal of a mirror warm up the car to room temperature (near +20°С). At lower temperature clips can break.

REMOVAL

1. Cast away a mirror upward.
Usual mirror 2. Paste over edge of a mirror and edge of the case of a mirror with a tape for protection against damages. 3. Take out a mirror from below a wooden wedge. It can be extended also from below fingers.
Automatically no-glare mirror 4. Displace a small screw-driver a support (the shooter on an accompanying illustration) to the right. It allows to open a bayonetny lock and carefully to remove a mirror. 5. Rasstykuyte shtekerny connection of heating of a mirror and diafragmiruyushchy automatic equipment.
6. Remove a mirror.

INSTALLATION

1. Join shtekerny connection of heating of a mirror and diafragmiruyushchy automatic equipment.
2. Establish a mirror so that clips were under pads.
Usual mirror 3. Press a mirror directly under clips and fix it. Enclose a rag not to leave on a mirror fingerprints.
Automatically no-glare mirror 4. Press a mirror. Enclose a rag not to leave fingerprints. Displace a support a small screw-driver to the left so that it was vertical.
5. Check mirror work.