E39 series BMW 5

since 1996-2001 of release

Repair and car operation



E39 BMW
+ Introduction
+ Maintenance instruction
+ Current leaving and service
+ Engine
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Manual transmission
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
- Body
   Care of a body
   Care of the panels of furnish made of vinyl
   Care of an upholstery and salon rugs
   Repair of insignificant damages of body panels
   Repair of considerable damages of a body
   Body gaps
   Removal and installation of a front bumper
   Removal and installation of shock-absorbers of a front bumper
   Removal and installation of a rear bumper
   Removal and installation of the shock-absorber of a rear bumper
   Removal and installation of a forward wing
   Removal and cowl installation
   Adjustment of provision of a cowl
   Removal and trunk lid installation
   Adjustment of provision of a trunk lid
   Removal and installation of back facing of a luggage carrier
   Removal and installation of the lock of a cover of the luggage carrier/cylinder of the lock
   Removal and installation of a gas-filled emphasis of a cowl/trunk lid
   Slip replacement / firm inscription
   Removal, installation and door adjustment
   Removal and installation of facing of a door
   Removal and installation of the door lock
   Removal and installation of the external handle of a door
   Removal and installation of the cylinder of the lock
   Removal and installation of the electric motor/microswitch of the uniform lock
   Removal, installation and adjustment of door glass
   Removal and installation of an electric window regulator
   Removal and installation of an external mirror
   Removal and installation of glass of a mirror
   Removal and installation of the case of an external mirror
   Removal and installation of an internal mirror
   Removal and installation of the central console
   Removal and installation of the electric motor of the movable panel of the hatch of a roof
   Removal and installation of a forward seat
   Device of a tension of a seat belt
   Security measures at the handling of the device of a tension of a belt
   Protection of the device of a tension of a belt
   Removal and installation of a back seat
   Removal and shelf installation under a headdress
   Removal and installation of a jalousie of back glass
+ Onboard electric equipment
+ electric equipment Schemes
+ System of onboard diagnostics





Removal and installation of the central console

 REMOVAL

1. Uncover the gear shifting lever.

2. Remove the switch of the alarm system and the uniform lock. For this purpose through an opening under the lever of gear shifting wring out aside penoplastovy isolation and squeeze out the switch from below. Rasstykuyte shtekerny connection.
3. Rasstykuyte shtekerny connection of the lighter through an opening under the gear shifting lever.
4. Remove the control unit a heater or the conditioner, address to the Section Removal and control unit installation by a heater or the conditioner.

The control unit has dense landing. Therefore at first remove the central console, and then squeeze out the control unit from a reverse side.

5. Squeeze out the switch under the control unit through an opening under the control unit. Rasstykuyte shtekerny connection.

6. Remove at the left and on the right lateral rugs. For this purpose turn out a bolt (1). Displace forward a lateral rug and disconnect it from clips.

7. Unscrew screws (2) and (3).

8. Uncover the parking brake from above consoles, incline it forward and disconnect from below.

9. Weaken the screw (4).
10. Turn out bolts (5) and (6), uncover.

11. Disconnect a lateral cover of the lever of the parking brake. For this purpose take a cover behind sideways aside seats of the driver and take out.

12. Press a back lattice of cooling (1) a little upward and a screw-driver sideways remove the holder a banok or a box (2) (an arrow on an accompanying illustration).

13. Displace a cooling lattice down and remove it.

14. Turn out two screws of fastening (7) and (8).

15. Shift a seat completely back and turn out in a back part at the left and on the right below on two bolts of fastening, having removed a small screw-driver of a cover (11).

16. Wring out aside isolation of a casing of gear shifting and turn out the screw (9).

17. Turn out a bolt (10).

18. Raise behind the central console a little. Rasstykuyte under it shtekerny connection of a lamp of illumination of an ashtray. Previously mark the tip with a tape.
19. Establish both lobbies of a seat, a back and translate the lever of gear shifting or the selector possibly further back.

20. Raise behind the central console, pull back, towards a seat of the forward passenger and take out.


 INSTALLATION

1. Establish the central console from a seat of the forward passenger.
2. Join shtekerny connection of the switch of the parking brake under the console.
3. Establish the control unit a heater or the conditioner, address to the Section Removal and control unit installation by a heater or the conditioner.
4. Fix a cover of the lever of gear shifting.