E39 series BMW 5

since 1996-2001 of release

Repair and car operation



E39 BMW
+ Introduction
+ Maintenance instruction
+ Current leaving and service
+ Engine
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Manual transmission
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
- Body
   Care of a body
   Care of the panels of furnish made of vinyl
   Care of an upholstery and salon rugs
   Repair of insignificant damages of body panels
   Repair of considerable damages of a body
   Body gaps
   Removal and installation of a front bumper
   Removal and installation of shock-absorbers of a front bumper
   Removal and installation of a rear bumper
   Removal and installation of the shock-absorber of a rear bumper
   Removal and installation of a forward wing
   Removal and cowl installation
   Adjustment of provision of a cowl
   Removal and trunk lid installation
   Adjustment of provision of a trunk lid
   Removal and installation of back facing of a luggage carrier
   Removal and installation of the lock of a cover of the luggage carrier/cylinder of the lock
   Removal and installation of a gas-filled emphasis of a cowl/trunk lid
   Slip replacement / firm inscription
   Removal, installation and door adjustment
   Removal and installation of facing of a door
   Removal and installation of the door lock
   Removal and installation of the external handle of a door
   Removal and installation of the cylinder of the lock
   Removal and installation of the electric motor/microswitch of the uniform lock
   Removal, installation and adjustment of door glass
   Removal and installation of an electric window regulator
   Removal and installation of an external mirror
   Removal and installation of glass of a mirror
   Removal and installation of the case of an external mirror
   Removal and installation of an internal mirror
   Removal and installation of the central console
   Removal and installation of the electric motor of the movable panel of the hatch of a roof
   Removal and installation of a forward seat
   Device of a tension of a seat belt
   Security measures at the handling of the device of a tension of a belt
   Protection of the device of a tension of a belt
   Removal and installation of a back seat
   Removal and shelf installation under a headdress
   Removal and installation of a jalousie of back glass
+ Onboard electric equipment
+ electric equipment Schemes
+ System of onboard diagnostics





Security measures at the handling of the device of a tension of a belt

   •  Replacement and check of devices of a tension of a belt of a safety / safety cushion should be made by specialized workshops. Carrying out any constructive changes with the specified devices is not allowed.

   •  If as a result of car failure the device of a tension of a seat belt worked, it it is necessary to replace on new (work HUNDRED).

   •  Before performance of any works with the device of a tension of a belt it is necessary to disconnect a weight cable from the storage battery. For an exception of casual contact the tip of a cable is necessary for isolating.

   •  If not worked device of a tension was removed from the car, to store it it is necessary so that casual access to it was excluded.

   •  The device of a tension and the control unit to them are sensitive to blows. If they were dropped from height by more than 50 cm, to apply them does not follow.

   •  By production of welding works the clip of the welding device should be attached directly in a welding place. Just in case the control unit should be disconnected by the device of a tension.

   •  The control unit a pillow the safety/device of a tension is under the central console. For an exception of failures in its work do not place in близи it any magnets.

   •  It is not necessary to subject the device of a tension and the control unit even to short-term influence of temperatures is higher +90°С. The damaged elements are not subject to repair and they cannot be opened. Before their installation again check, whether the negative cable of the storage battery is disconnected and whether the plug is isolated.

   •  It is not allowed to remove and utilize the device of a tension of a seat belt independently at all. Danger of explosion!

System check

 PERFORMANCE ORDER

1. After ignition inclusion a control lamp the pillow of the safety/device of a tension of a belt should light up and approximately through 4 pages go out.
2. If the control lamp after inclusion of ignition does not light up, it indicates malfunction in system.
3. If the control lamp does not die away or lights up during movement, in system of a safety cushion there is a malfunction. It is necessary to consider that the safety cushion and the device of a tension do not function.