Check of a heater of back glass
After inclusion of heating of back glass its field having threads of heating, should be cleared of ice after a while.
|
1. In the presence of malfunctions at first check a safety lock in the block of safety locks. 2. If a safety lock as it should be, check reliability of connection of the tip at the left and on the right back glass. If necessary smooth out from corrosion. |
3. If after that heating of back glass still does not work, check wires and the switch, and also a chain. |
4. If heating threads have break, to liquidate it it is possible by means of a usual zilber-varnish. For this purpose clear the damaged place a thinner or ethylene. Address to an accompanying illustration. 5. From two parties of the torn-off thread paste a sticky tape and with a small brush put a zilber-varnish. 6. Let's dry to a covering at temperature +25°С within 24 hours. The hair dryer can be applied to this purpose. At temperature +150°С the covering dries within 30 minutes. |
|
|
Do not include heating of back glass, the covering did not dry yet. Do not apply to cleaning of the damaged place gasoline or other solvents. |
|