E39 series BMW 5

since 1996-2001 of release

Repair and car operation



E39 BMW
+ Introduction
+ Maintenance instruction
+ Current leaving and service
+ Engine
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Manual transmission
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
- Onboard electric equipment
   Diagnostics of malfunctions of onboard electric equipment - the general information
   Safety locks
   Fusible inserts
   Chain breakers (thermal relays)
   Relay
   Relay check
   Check of filament lamps
   Check of electric motors
   Check of electric switches
   Check of switches of lamps and electric motors
   Check of sensors
   Check of the electric motor of a screen wiper
   Stoplight check
   Check of a heater of back glass
   Removal and switch installation
   Removal and installation of the sensor of temperature
   Removal, installation and check of a sound signal
   Initialization of remote control by the uniform lock
   Adjustment of range of light of headlights
   Removal and installation of the electric motor of adjustment of range of light
   Replacement of safety locks
   Arrangement of safety locks
   Lighting devices
   Replacement of filament lamps
   Removal and headlight installation
   Adjustment of headlights
   Removal and installation of a back lamp
   Monitors
   Removal and installation of the block of the dashboard
   Replacement of lamps of the block of the dashboard
   Removal and installation of the switch of signals of a turn/screen wiper
   Removal and radio receiver installation
   Screen wiper
   Replacement of brushes of a screen wiper
   Removal, installation and adjustment snuffled a stekloomyvatel
   Removal and installation of a drive of a screen wiper/cover
   Removal and installation of the electric motor of a screen wiper
   Check and replacement of the pump of a stekloomyvatel
   Work with electric circuits
+ electric equipment Schemes
+ System of onboard diagnostics





Replacement of filament lamps

It is recommended to have with itself in the car spare lamps. On sale the box with a set of spare lamps is offered. The list of lamps is provided in Specifications.

Switch off the switch of the corresponding lamp.

Headlights

Halogen lamps of a driving, passing beam and antifog light are under pressure. For protection of eyes use points, for protection of hands - gloves. Otherwise at damage of a lamp there is a danger of a travmirovaniye.


 PERFORMANCE ORDER

1. Open a cowl.

 

2. Turn to the left against the stop the holder of a lamp of a passing beam (1) and take out it.

3. Take out a lamp and replace it.
4. Establish the holder of a lamp of a passing beam and turn it to the right against the stop.
5. Turn to the left against the stop the holder of a lamp of a driving beam (2) and take out it
6. Rasstykuyte shtekerny connection.
7. Establish the new holder of a lamp with a lamp on a connector and fix it.
8. Establish the holder of a lamp of a driving beam and turn to the right against the stop.

Parking light

 PERFORMANCE ORDER

1. Turn to the left against the stop the holder of a lamp of a parking light (3) and take out it.

2. Take out a lamp and replace it.

3. Insert into the case the holder of a lamp a big pad upward and turn to the right.

Turn signal the forward

 PERFORMANCE ORDER

1. Compress the holder of a lamp for pads and take out it back.
2. Slightly press a lamp in the holder, turn on the left and take out.
3. Insert a new lamp, press it in the holder, turn to the right and fix.
4. Press the holder of a lamp and fix it.

Lateral repeater of turn

 PERFORMANCE ORDER

1. Press a lamp fingers at a back edge forward and take out.
2. Turn a lamp on the left, having slightly pressed and take out.
3. Slightly press on a new lamp, turn to the right and fix it.

Fog light

Halogen lamps of a driving, passing beam and antifog light are under pressure. For protection of eyes use points, for protection of hands by gloves. Otherwise at damage of a lamp there is a danger of a travmirovaniye.


 PERFORMANCE ORDER

1. Remove a clip of a decorative lattice. For this purpose take out a pin (2), then a clip (1).

2. Disconnect a decorative lattice above and take out it.
3. Take out forward a cover near a fog light.

3. Turn out 2 two bolts of fastening and take aside a fog light.

4. Press a spring (1) from a reverse side in the arrow direction on an accompanying illustration.

5. Hook a cover (2) on the one hand and disconnect it with another.

6. Disconnect a spring clip (1) of the holder (2).

7. Remove covers of contacts and replace a lamp.
8. Fix a new lamp a clip.
9. Check a condition of laying (3) in a cover, if necessary replace.
10. Insert a cover, press it and fix a spring clip.
11. Insert a fog light and fix it screws.
12. Fix a decorative lattice, press a clip and fix it razzhimny pins.

Back lamp

 PERFORMANCE ORDER

1. Open a trunk lid.
2. Remove lateral facing.

3. Turn to the left on 90 ° a clip (1) and remove the holder of a lamp (2).

4. Slightly press a lamp in the holder, turn to the left and take out.

5. Insert a new lamp, press it a little in the holder, turn to the left and fix.

6. Establish the holder of a lamp and turn a clip.

It is central the located stoplight

 PERFORMANCE ORDER

1. Open a trunk lid.
2. Remove a screw-driver a black plastic cover from the bottom party of a hanger under headdresses.
3. Turn to the left the holder of a lamp and take out it.
4. Insert a new lamp, having pressed it a little in the holder, turn to the right and fix.
5. Establish the holder of a lamp and fix, having turned to the right.
6. Fix a plastic cover from the bottom party of the shelf under headdresses.

Lamp of illumination of registration plate

Capacity of a lamp of 5 W

 REPLACEMENT

1. Insert a screw-driver into a cut and press to the right, as shown an arrow; the lamp leaves fastening.

2. Remove a lamp and replace a lamp

Plafonds

Forward plafond

Main lamp (10 W), lamps of individual lighting (10 W)

 PERFORMANCE ORDER

1. Main lamp. Squeeze out a plafond, having hooked it sideways a screw-driver, and remove glass then take a lamp from contact holders.
2. Lamp of individual lighting. Take out a lamp, having slightly pressed on it and having turned to the left

Back plafond

Main lamp (10 W), lamp of individual lighting (5 W)

 PERFORMANCE ORDER

1. Squeeze out a plafond, having hooked it a screw-driver, having inserted into dredging from above
2. Main lamp. Having wrung out a uvula on a reflector, replace a lamp
3. Lamp of individual lighting. Take out a lamp, having slightly pressed on it and having turned to the left

Lamps of illumination of a niche for feet

Capacity of lamps of 5 W

 PERFORMANCE ORDER

1. Remove lamp glass, having hooked it sideways a screw-driver
2. Replace a lamp

Lamp of illumination of a ware box

Capacity of a lamp of 5 W

 PERFORMANCE ORDER

1. Squeeze out a lamp, having hooked it a screw-driver inserted into dredging
2. Remove a reflector
3. Replace a lamp

Lamps of illumination of a luggage carrier

Lamp under the shelf behind back seats: 10 W, halogen
Lamp in a trunk lid: 10 W

 PERFORMANCE ORDER

1. Squeeze out a lamp, having hooked it a screw-driver inserted into dredging
2. Remove a reflector
3. Replace a lamp