E39 series BMW 5

since 1996-2001 of release

Repair and car operation



E39 BMW
+ Introduction
+ Maintenance instruction
+ Current leaving and service
+ Engine
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Manual transmission
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
- Onboard electric equipment
   Diagnostics of malfunctions of onboard electric equipment - the general information
   Safety locks
   Fusible inserts
   Chain breakers (thermal relays)
   Relay
   Relay check
   Check of filament lamps
   Check of electric motors
   Check of electric switches
   Check of switches of lamps and electric motors
   Check of sensors
   Check of the electric motor of a screen wiper
   Stoplight check
   Check of a heater of back glass
   Removal and switch installation
   Removal and installation of the sensor of temperature
   Removal, installation and check of a sound signal
   Initialization of remote control by the uniform lock
   Adjustment of range of light of headlights
   Removal and installation of the electric motor of adjustment of range of light
   Replacement of safety locks
   Arrangement of safety locks
   Lighting devices
   Replacement of filament lamps
   Removal and headlight installation
   Adjustment of headlights
   Removal and installation of a back lamp
   Monitors
   Removal and installation of the block of the dashboard
   Replacement of lamps of the block of the dashboard
   Removal and installation of the switch of signals of a turn/screen wiper
   Removal and radio receiver installation
   Screen wiper
   Replacement of brushes of a screen wiper
   Removal, installation and adjustment snuffled a stekloomyvatel
   Removal and installation of a drive of a screen wiper/cover
   Removal and installation of the electric motor of a screen wiper
   Check and replacement of the pump of a stekloomyvatel
   Work with electric circuits
+ electric equipment Schemes
+ System of onboard diagnostics





Adjustment of headlights

The correct adjustment of headlights is of great importance for traffic safety. Exact adjustment of headlights demands use of the special device. Therefore here only it is specified, where adjustment and what conditions is made should be for this purpose executed.
   a) Pressure of air in tires should be equally established.
   b) The car should not be loaded. On a place of the driver there should be a person in mass of 75 kg.
   c) The fuel tank should be filled, at least, for 90 %.
   d) The car should stand on an equal platform.
   e) The forward part of the car is necessary for "besieging" several times that the forward suspension bracket occupied the working situation.
   f) Adjustment of range of headlights should be established on “0”.
   g) Adjustment of headlights should be carried out only at a passing beam. The inclination of a light stream for a standard headlight should make 10 cm on 10 m of length.

 PERFORMANCE ORDER

1. Adjustment of headlights is made by rotation of adjusting screws (1) and/or (2).
   1 screw of adjustment down
   2 screw of adjustment across

2. On an illustration the right headlight is shown. At the left headlight an arrangement of screws the mirror.

Fog lights

 PERFORMANCE ORDER

1. Adjust an inclination of fog lights a screw-driver through an opening in a decorative lattice.
2. The inclination of a light stream for a standard headlight should make 10 cm on 10 m of length.