E39 series BMW 5

since 1996-2001 of release

Repair and car operation



E39 BMW
+ Introduction
+ Maintenance instruction
+ Current leaving and service
+ Engine
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Manual transmission
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
- Onboard electric equipment
   Diagnostics of malfunctions of onboard electric equipment - the general information
   Safety locks
   Fusible inserts
   Chain breakers (thermal relays)
   Relay
   Relay check
   Check of filament lamps
   Check of electric motors
   Check of electric switches
   Check of switches of lamps and electric motors
   Check of sensors
   Check of the electric motor of a screen wiper
   Stoplight check
   Check of a heater of back glass
   Removal and switch installation
   Removal and installation of the sensor of temperature
   Removal, installation and check of a sound signal
   Initialization of remote control by the uniform lock
   Adjustment of range of light of headlights
   Removal and installation of the electric motor of adjustment of range of light
   Replacement of safety locks
   Arrangement of safety locks
   Lighting devices
   Replacement of filament lamps
   Removal and headlight installation
   Adjustment of headlights
   Removal and installation of a back lamp
   Monitors
   Removal and installation of the block of the dashboard
   Replacement of lamps of the block of the dashboard
   Removal and installation of the switch of signals of a turn/screen wiper
   Removal and radio receiver installation
   Screen wiper
   Replacement of brushes of a screen wiper
   Removal, installation and adjustment snuffled a stekloomyvatel
   Removal and installation of a drive of a screen wiper/cover
   Removal and installation of the electric motor of a screen wiper
   Check and replacement of the pump of a stekloomyvatel
   Work with electric circuits
+ electric equipment Schemes
+ System of onboard diagnostics





Removal and installation of the block of the dashboard

 REMOVAL

1. Lower a steering column completely down and put forward.
2. Remove wooden peaks at the left and on the right a steering column.

3. Uncover. For this purpose unscrew three screws of fastening from below.

4. Turn out three screws above and remove a frame. Rasstykuyte shtekerny connection of the switch of a fog light also hang up a frame cover. If it is necessary, расстыкуйте shtekerny connection of the switch of a passing beam. Light in this case lights up and the light signaling device joins. That it to exclude, take out the corresponding safety lock.

Depending on execution the cover can be fixed by two screws above and below and is in addition fixed above.

5. Turn out two screws of fastening and cast away the dashboard block.

6. Rasstykuyte shtekerny connection also remove it. For this purpose open a clip and take away from a cable.


 INSTALLATION

1. Join shtekerny connection and fix it a clip. Watch that the clip was reliably fixed.
2. Insert the dashboard block into an opening and fix screws.
3. Join shtekerny connection of the switch of light.
4. Establish a cover and fix it screws.
5. Establish into place wooden peaks.
6. Establish in normal situation a steering column.