E39 series BMW 5

since 1996-2001 of release

Repair and car operation



E39 BMW
+ Introduction
+ Maintenance instruction
+ Current leaving and service
+ Engine
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Manual transmission
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
- Onboard electric equipment
   Diagnostics of malfunctions of onboard electric equipment - the general information
   Safety locks
   Fusible inserts
   Chain breakers (thermal relays)
   Relay
   Relay check
   Check of filament lamps
   Check of electric motors
   Check of electric switches
   Check of switches of lamps and electric motors
   Check of sensors
   Check of the electric motor of a screen wiper
   Stoplight check
   Check of a heater of back glass
   Removal and switch installation
   Removal and installation of the sensor of temperature
   Removal, installation and check of a sound signal
   Initialization of remote control by the uniform lock
   Adjustment of range of light of headlights
   Removal and installation of the electric motor of adjustment of range of light
   Replacement of safety locks
   Arrangement of safety locks
   Lighting devices
   Replacement of filament lamps
   Removal and headlight installation
   Adjustment of headlights
   Removal and installation of a back lamp
   Monitors
   Removal and installation of the block of the dashboard
   Replacement of lamps of the block of the dashboard
   Removal and installation of the switch of signals of a turn/screen wiper
   Removal and radio receiver installation
   Screen wiper
   Replacement of brushes of a screen wiper
   Removal, installation and adjustment snuffled a stekloomyvatel
   Removal and installation of a drive of a screen wiper/cover
   Removal and installation of the electric motor of a screen wiper
   Check and replacement of the pump of a stekloomyvatel
   Work with electric circuits
+ electric equipment Schemes
+ System of onboard diagnostics





Removal and radio receiver installation

REMOVAL

1. Remove the button of a regulator of loudness.

2. Insert a screw-driver into a cut near an axis of a regulator of loudness and turn on 90 °. Take out to the left a screw-driver and together with it the control panel and take away them to the right.

If the screw-driver directly does not enter into a groove, put it, turn on 90 ° and, thus, having displaced a clamp to the right, at the same time open a groove. Turn a screw-driver further and insert into a groove.

3. Rasstykuyte shtekerny connection. For this purpose reject aside a clip.

4. Turn to the left two screws of fastening (3) radio receivers with an internal shestigrannik so that it could be taken out easily.

5. Rasstykuyte multipolar shtekerny connection (1) screw-driver. Disconnect a cable of weight (2). Disconnect an antenna wire (3).


 INSTALLATION

1. Join multipolar shtekerny connection and an antenna wire from a reverse side of a radio receiver. Fix the screw a weight cable.
2. Insert a radio receiver into a dashboard opening.
3. Fix screws with an internal shestigrannik.
4. Establish multipolar shtekerny connection at the radio receiver control panel. Cast away a clip and fix it.
5. Insert the control panel into an opening of the dashboard of the car so that it was fixed.
6. Establish the button of a regulator of loudness.