E39 series BMW 5

since 1996-2001 of release

Repair and car operation

+ Introduction
+ Maintenance instruction
+ Current leaving and service
+ Engine
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Manual transmission
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
- Onboard electric equipment
   Diagnostics of malfunctions of onboard electric equipment - the general information
   Safety locks
   Fusible inserts
   Chain breakers (thermal relays)
   Relay check
   Check of filament lamps
   Check of electric motors
   Check of electric switches
   Check of switches of lamps and electric motors
   Check of sensors
   Check of the electric motor of a screen wiper
   Stoplight check
   Check of a heater of back glass
   Removal and switch installation
   Removal and installation of the sensor of temperature
   Removal, installation and check of a sound signal
   Initialization of remote control by the uniform lock
   Adjustment of range of light of headlights
   Removal and installation of the electric motor of adjustment of range of light
   Replacement of safety locks
   Arrangement of safety locks
   Lighting devices
   Replacement of filament lamps
   Removal and headlight installation
   Adjustment of headlights
   Removal and installation of a back lamp
   Removal and installation of the block of the dashboard
   Replacement of lamps of the block of the dashboard
   Removal and installation of the switch of signals of a turn/screen wiper
   Removal and radio receiver installation
   Screen wiper
   Replacement of brushes of a screen wiper
   Removal, installation and adjustment snuffled a stekloomyvatel
   Removal and installation of a drive of a screen wiper/cover
   Removal and installation of the electric motor of a screen wiper
   Check and replacement of the pump of a stekloomyvatel
   Work with electric circuits
+ electric equipment Schemes
+ System of onboard diagnostics

Replacement of brushes of a screen wiper

Replacement of brushes of a screen wiper is necessary for making at poor quality of purification of glass. Thus it is possible to replace or only brushes, or complete with shchetkoderzhatel. If the brush is replaced only, it is necessary to check, whether the shchetkoderzhatel has deformations.


1. Raise a brush and keep it in such situation.

2. Displace a clip (1) in the direction of an arrow and remove a brush towards a windscreen.

3. Compress пассатижами both steel tires from the closed party of a brush and take out sideways from the top bracket. Take out rubber together with tires from the rest of brackets.

4. Insert a new brush without the tire into the bottom brackets.

5. Enter both tires into the first flute of a brush so that grooves of tires showed towards rubber and fix in flute pads.
6. Compress both steel tires and a brush пассатижами and insert into the top bracket so that bracket pads from both parties entered into grooves (shooter) of a brush.
7. Insert a brush via the lever and displace back a lock clip.
8. Cast away back the lever. Watch that the brush everywhere adjoined to a windscreen.