E39 series BMW 5

since 1996-2001 of release

Repair and car operation



E39 BMW
+ Introduction
+ Maintenance instruction
+ Current leaving and service
+ Engine
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Manual transmission
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
- Onboard electric equipment
   Diagnostics of malfunctions of onboard electric equipment - the general information
   Safety locks
   Fusible inserts
   Chain breakers (thermal relays)
   Relay
   Relay check
   Check of filament lamps
   Check of electric motors
   Check of electric switches
   Check of switches of lamps and electric motors
   Check of sensors
   Check of the electric motor of a screen wiper
   Stoplight check
   Check of a heater of back glass
   Removal and switch installation
   Removal and installation of the sensor of temperature
   Removal, installation and check of a sound signal
   Initialization of remote control by the uniform lock
   Adjustment of range of light of headlights
   Removal and installation of the electric motor of adjustment of range of light
   Replacement of safety locks
   Arrangement of safety locks
   Lighting devices
   Replacement of filament lamps
   Removal and headlight installation
   Adjustment of headlights
   Removal and installation of a back lamp
   Monitors
   Removal and installation of the block of the dashboard
   Replacement of lamps of the block of the dashboard
   Removal and installation of the switch of signals of a turn/screen wiper
   Removal and radio receiver installation
   Screen wiper
   Replacement of brushes of a screen wiper
   Removal, installation and adjustment snuffled a stekloomyvatel
   Removal and installation of a drive of a screen wiper/cover
   Removal and installation of the electric motor of a screen wiper
   Check and replacement of the pump of a stekloomyvatel
   Work with electric circuits
+ electric equipment Schemes
+ System of onboard diagnostics





Removal, installation and adjustment snuffled a stekloomyvatel

REMOVAL

1. Open a cowl.

 

2. Remove the lower part of facing of a cowl and cast away it. For this purpose turn out plastic screws (1) of a clip (2) and take out a screw-driver a clip.

3. Rasstykuyte shtekerny connection (1).

4. Disconnect a hose of supply of liquid to a nozzle (2).
5. Press a stopper and insert a jet (3) through an opening in a cowl.


 INSTALLATION

1. Press a nozzle into an opening of a cowl and fix it.
2. Put on a hose of supply of liquid
3. Rasstykuyte shtekerny connection.
4. Lower a cowl. Press a clip and screw plastic screws.


 ADJUSTMENT

1. Mark a felt-tip pen on a windscreen the points shown on an accompanying illustration, according to the sizes specified below, and include a stekloomyvatel. Streams should get to the corresponding points. Otherwise nozzles are necessary for adjusting.
2. The sizes for adjustment of streams of stekloomyvatel.
А1 = 226
А2 = 540
В1 = 530
В2 = 506
С1 = 460
С2 = 450
D1 = 210
D2 = 505

3. The directions of streams snuffled can be adjusted by means of a wire or a needle. HUNDRED apply the special HAZET 4850-1 tool to this purpose. The tool consists of a telescopic core with a needle on the end. The nozzle direction, than, for example, a needle allows to adjust the put-forward core more precisely.