| 1. Periodically check liquid level in system of hydrostrengthening of a wheel in order to avoid emergence of problems with management of the car, such, as damage of the steering pump. Act as follows.
| Do not hold a steering wheel turned against the stop in this or that party more than five seconds. It can put out of action the steering pump. |
|
2. The tank of system of hydrostrengthening of a wheel is located in the left part of an impellent compartment and has an unscrewing cover with built in in it measuring the shchupy. |
 |
3. Park the car on an equal platform and cock the parking brake.
4. Level of oil can be checked at cold or heated-up oil. Heated-up oil has temperature near + 80°С, cold oil has ambient temperature.
5. Unscrew a stopper of the tank of oil on the cooled engine. The level index on a stopper wipe a pure rag. |
6. Put a cover on a mouth, without screwing up it, and remove again. Level of oil should be between labels on the index. If necessary add oil. Added oil should be authorized BMW firm. Add surely new oil since even insignificant pollution can cause failures of the hydraulic booster. |
 |
7. Start the engine and if necessary add oil that it was between marks in the index.
8. At the working engine turn several times a steering wheel from an emphasis against the stop. Thus from system air is removed.
9. Stop the engine.
|
| The modulation of liquid is allowed no more than 5 mm above the MOVE. Remove surpluses with a pure syringe. Close a cover. |
Check sealing rings on a stopper. If necessary replace.
10. Close the tank a stopper.
11. If the frequent dolivaniye of liquid is required, check hoses and shtutserny connections of system of hydrostrengthening of a wheel on existence of signs of wear and leaks.
12. Check a condition of a driving belt (address to the Section Check of a condition of driving belts). |
