General information on control
The term "control" is used in this Management rather for designation of a complex of procedures, than one separate procedure.
If from the moment of car purchase the schedule of routine maintenance is strictly observed, frequent checks of level of liquids and a condition of components subject to raised wear as it is offered in this Management will be carried out, the engine will long remain in a good working condition, and need for carrying out any additional work will be minimized.
Is more often, however, happens so that the engine works inefficiently owing to neglect with regular service. Even more often it happens upon purchase of the second-hand car which owners did not trouble themselves with frequent and regular checks and service. In this case, besides performance of usual procedures on routine maintenance, it will be necessary to make setup of the engine.
The first step in any procedure of control or diagnostics for the purpose of improvement of operation of the engine is check of extent of compression in cylinders. Check of a compression will help to define a condition of internal components of the engine and should serve as the index at carrying out control and repair. If, for example, check of extent of compression indicates serious internal wear of the engine, usual control will not help to improve its work and will be waste of time and money. As procedure of check of extent of compression is the extremely important, the expert owning the equipment specially intended for this purpose should see off her.
For engine reduction in a good working condition performance of the following procedures more often is required.
Minimum settings
• Check of all liquids connected with operation of the engine (The section Check of levels of liquids) • Check of a condition of all hoses of an impellent compartment (Section Check of a condition and replacement of hoses of an impellent compartment)
• Check of a condition of driving belts (Section Check of a condition of driving belts) • Cleaning, survey and check of a charge of the battery (Section Check of a condition of the battery, care of it and charging. Replacement of an element of a food DU brelka)
• Replacement of spark plugs (Section Check and replacement of spark plugs) • Check of the air filter (Section Replacement of an element of the air filter) • Check of system of cooling (Section Check of functioning of system of cooling)
General settings
All points of the minimum control listed above, plus: • Check of system of ignition (address to Head engine Electric equipment) • Check of system of a charge (address to Head engine Electric equipment) • Check of fuel system (address to Head of the Power supply system and release)
|