E39 series BMW 5

since 1996-2001 of release

Repair and car operation

+ Introduction
+ Maintenance instruction
+ Current leaving and service
+ Engine
+ Systems of cooling, heating
- Power supply system and release
   + Power supply system
   - System of injection of the petrol engine
      Memory of malfunctions
      Security measures and rules of observance of purity at work with injection system
      Work of system of injection
      Check of systems of ignition and injection
      Adjustment of a drive of gas
      Removal and installation of a branch pipe of a butterfly valve
      Removal, check and installation of the valve of adjustment of idling
      Check, removal and installation of the sensor of temperature
      Check of injectors
      Removal and installation of injectors
   + Power supply system of the diesel engine
   + System of production of the fulfilled gases
+ engine Electric equipment
+ Manual transmission
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ electric equipment Schemes
+ System of onboard diagnostics

погрешность и точность приближения 8 класс
погрешность и точность приближения 8 класс

Adjustment of a drive of gas

The drive of gas is very sensitive to breaks and consequently, at its installation, it is necessary to be careful. The small break can lead later to break in the course of movement. A cable having damages, it is not necessary to establish.
At cars with automatic adjustment of speed (tempostaty) at the lever of a butterfly valve the additional drive of gas is fixed. If it is necessary, the specified cable is disconnected similar to the basic.



1. Completely press a pedal of gas and press it in this situation. For this purpose establish wooden whetstone between a seat and a pedal.

2. Press the butterfly valve lever, having established it in the provision of full gas and turn an adjusting nut (1) so that the cable stretched, address to an illustration. Release a gas pedal.

Detachment of a drive of gas from the butterfly valve lever


1. Give gas the butterfly valve lever to unload nipples of a cable of gas. Address to an accompanying illustration.
2. Take out a nipple (2) of a segment.
3. Take out a cable cover from a support (1).

Cable connection


1. Pass a cable via the rubber plug of a support.
2. Give gas the butterfly valve lever, connect a cable nipple. Check adjustment of a drive of gas.