E39 series BMW 5

since 1996-2001 of release

Repair and car operation



E39 BMW
+ Introduction
+ Maintenance instruction
+ Current leaving and service
+ Engine
+ Systems of cooling, heating
+ Power supply system and release
- Engine electric equipment
   + ignition System
   - System of preheat of the diesel engine
      Check, removal and installation of candles of an incandescence
      Check, removal and installation of the relay of preheat
   + charge and start Systems
+ Manual transmission
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ electric equipment Schemes
+ System of onboard diagnostics


Heavy Metal & Reflected


Check, removal and installation of candles of an incandescence

In the presence of difficulties at start of the engine it is necessary to check first of all a compression in engine cylinders. If the compression is insufficient, the engine at low temperature is not started, address to the Section compression Check.

The DDE control unit is equipped with the memory of malfunctions which is writing down malfunctions, arisen in an electric part of fuel system of a diesel engine. On HUNDRED data containing in memory, can be считаны by means of the special device.


 CHECK

1. Remove covers of the engine and a pressurization pipe over glow plugs.

2. Glow plugs are under soaking-up channels.

3. Disconnect a cable to glow plugs (an arrow on an accompanying illustration).

4. Attach the device for tension check to positive contact (+) and in turn to each glow plug.

5. If the light-emitting diode lights up: Glow plug as it should be. For more exact check it is necessary to measure by the ampermeter current size.

6. If the light-emitting diode does not light up: The glow plug is damaged. Replace it.


 REMOVAL

1. Remove the inlet pipeline, address to the Section Removal and installation of the inlet pipeline

2. Disconnect cables (1) and (2). Turn out glow plugs and check visually. Address to an accompanying illustration.


INSTALLATION

1. Grease a carving of candles of an incandescence with high-temperature copper CRC paste. Screw candles. Moment of an inhaling of 25 Nanometers.

It is not necessary to exceed the specified moment of an inhaling since the ring gap between a heating core and a carving part of a candle can increase.

2. Attach a cable to glow plugs. A nut of fastening tighten the moment of 5 Nanometers.
3. Fix the inlet pipeline to a head of cylinders the moment of 25 Nanometers. All consolidations replace with the new. Support of the case of the oil filter and the pipeline of system of a retsirkulyatsiya fix to the inlet pipeline also the moment of 25 Nanometers.
4. Establish to the place of a cover of the engine and a pressurization pipe.

Glow plugs with the fused cores

The fused cores of candles of an incandescence often are a consequence of faulty work of nozzles.

At detection of the damaged candles (shooter) it is necessary to replace them and it is obligatory to check work of nozzles.