E39 series BMW 5

since 1996-2001 of release

Repair and car operation



E39 BMW
+ Introduction
+ Maintenance instruction
+ Current leaving and service
+ Engine
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Manual transmission
- Automatic transmission
   Removal and installation of automatic transmission
   Adjustment of a drive of gear shifting
   Check of level and replacement of oil of automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ electric equipment Schemes
+ System of onboard diagnostics


weltrade



Adjustment of a drive of gear shifting

Position of the selector (etc.) is established to P-R-N-D by a hummock drive of AT. Adjustment of a drive is carried out after AT installation or a switching drive.

 PERFORMANCE ORDER

1. Establish the selector in the situation "P".
2. Lift and establish the car on supports. Remove the bottom guard of an impellent compartment.

3. Weaken a nut (2) drives on the switching lever.

Not to bend a cable, at a nut otvorachivaniye surely hold tightening a bolt. If the cable was damaged, it is necessary to replace it, since after a while from will break.

4. Press the lever (3) a hand against the stop forward, i.e. in the movement direction. For AT it corresponds to the Parking mode.
5. Press a rod of a drive of a cable (4) in the direction against movement (shooter) and in this situation clamp tightening a bolt the moment of 10 Nanometers. Thus tightening a bolt hold from a provorachivaniye the second key not to bend a cable.
6. Establish the bottom guard of an impellent compartment. Lower the car on wheels.

Removal and installation of a cable of a drive

 PERFORMANCE ORDER

1. Unscrew a tightening nut (2).
2. Weaken nuts (5) at a support and remove a support.

3. Adjust a cable, see above.