E39 series BMW 5

since 1996-2001 of release

Repair and car operation

+ Introduction
+ Maintenance instruction
+ Current leaving and service
+ Engine
- Systems of cooling, heating
   + cooling System
   - Heater
      Removal and control unit installation by a heater or conditioner
      Removal and installation of the sensor of temperature of the control unit by a heater
   + air Conditioner
+ Power supply system and release
+ engine Electric equipment
+ Manual transmission
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ electric equipment Schemes
+ System of onboard diagnostics

Покраска авто цена смотрите на http://kuzovnoy-remont-minsk.by.

Removal and control unit installation by a heater or conditioner


1. Rasfiksiruyte control unit (1). For this purpose at the left and on the right in the places shown on an accompanying illustration, insert two щупа (2) and press thus spring clips (3).

Щупы should be inserted precisely in the places shown on an illustration, with use of some force. If the control unit thus does not act in film, remove the central console and then displace the block behind.

2. Take out the control unit.

3. Rasfiksiruyte also remove multiitem shtekerny connection (1). For this purpose press a stopper (2) down and incline a lock collar (3) aside. Address to an accompanying illustration. Thus the switch acts in film up.

4. Rasfiksiruyte other shtekerny connections.


1. Join and fix shtekerny connections.

2. Establish into place multiitem shtekerny connection (1). Connect it by means of the lock lever (3). Fix the lock lever (3). Check reliability of connection. Address to an accompanying illustration.

3. Establish the control unit, having pressed and having fixed it.